Flow Regimes > Regime 1: Stationary or Fixed Bed, No Sheet Flow

1: Fixed bed without suspension or sheet flow, constant Cvs.

Under laboratory circumstances with a constant spatial volumetric concentration Cvs, at low line speeds all the particles are in a stationary (fixed) bed at the bottom of the pipe. Above the bed the liquid is flowing through a smaller cross-section Aflow=Apipe-Abed. This gives a higher effective line speed vls,e=vls·Apipe/Aflow. Since the bottom of this cross–section consists of particles, the Darcy-Weisbach friction factor λ has to be determined by taking a weighted average of the friction factor of the bed λb and the friction factor of the pipe wall λw. The method of Miedema & Matousek (2014) can be applied to determine the Darcy-Weisbach friction coefficient λb on the bed. This method does not distinguish between fine and coarse particles. The particle diameter is used for the roughness to determine the Darcy-Weisbach friction coefficient λb.

The Shields parameter is below a Shields value of about 1 so no sheet flow occurs.

The total pressure loss is thus determined by viscous friction on the bed and the pipe wall.





 Login | Home | Resources | Site map | Traffic | 107 active visitors 

Fullxml powered website © fullxml.org
Last updated
Copyright 2001- © Dr.ir. S.A. Miedema - all rights reserved



Copyright © Dr.ir. S.A. Miedema

Send email to WebMaster with questions or comments about this website.